exception data

riacharda · Post by **riacharda** » Sun May 02, 2004 11:08 am

hi i'm new around here and i'm a bit familiar of how to apply mods using PPF-O-Matic. i downloaded ANIB1.1 and i used PPF-O-Matic to apply it. when i loaded bloodgulch it said Exception! Gathering Exception data. and it couldn't load. what should i do?

HoboRockAssassin · Post by **HoboRockAssassin** » Sun May 02, 2004 11:45 am

u just applied it wrong
read a tut u probably mixed up the map and the ppf patch in the two spots of the ppf-omatic

MasterNeoChief · Post by **MasterNeoChief** » Sun May 02, 2004 12:17 pm

Remember Exception error well.
You'll see it ALOT.
People refer it to MR. exception.

rossmum · Post by **rossmum** » Sun May 02, 2004 7:34 pm

MasterNeoChief wrote:You'll see it ALOT.

Yeah, especially if you're like me.

riacharda · Post by **riacharda** » Tue May 04, 2004 3:43 am

i'm sure i checked the place where i apply ANIB1.1. i put it on the patch section(bottom collumn) and Bloodgulch.map on topcolumn.

MasterNeoChief · Post by **MasterNeoChief** » Tue May 04, 2004 5:25 am

Yes, under ISO the map goes, and patch is ppf.

moch230 · Post by **moch230** » Thu May 06, 2004 5:23 pm

are you sure you are familliar to the ppf o matic? The top bar is for the original map file. The bottom is for the patch. If you have bg on top you have to add a bg file on the bottom. If you have bitmaps on top you have a new bitmaps on the bottom. Basically you have to have a matching patch.

HaloMods "Classic" Read-only Archive

exception data

exception data

it happened to me when i started.