tool help

clutch152 · Post by **clutch152** » Sat Sep 04, 2004 5:16 pm

when i open tool it opens for a split second to reveal that it "cannot read './toolbeta.map" or something to that extent then it closes imediatly thereafter. can anyone tell me what is wrong?

Haloman1337 · Post by **Haloman1337** » Mon Sep 06, 2004 1:09 pm

I'm pretty sure you have to open tool from command prompt, not by just clicking on tool.exe. However any tutorial could tell you better than I can. Good luck.

kaptainkommie · Post by **kaptainkommie** » Mon Sep 06, 2004 4:25 pm

He is correct. You must run tool from the command prompt (cmd.exe).

Captain_Lag · Post by **Captain_Lag** » Tue Sep 07, 2004 11:18 am

toolbeta.map thing you can ignore when you compile anything