Scenery Question

HMC Helljumper · Post by **HMC Helljumper** » Wed Jun 30, 2004 2:07 pm

I have already made several scenery tags and put them in Spiena nd played them. But I am dissapointed because I can't put prtals or anything on my scenery, and the same goes for spawn points and everyhting else. They go right through to the ground when I place them in Sapien. Does anyone know a solution to this problem (if th ere is one). Basically I am looking for a way to move the teleporters or flags or weapons or vehicles up or down in Sapien.

Thanks

geminijunodeluxe · Post by **geminijunodeluxe** » Wed Jun 30, 2004 3:16 pm

Ok in Sapien, to move objects up and down, select the type of object you want to move, then look to the side in the properties palette and change the Z-Axis, increase # to increase height, decrease # to decrease height.

HMC Helljumper · Post by **HMC Helljumper** » Wed Jun 30, 2004 6:06 pm

thx so much thats exactly wat i wanted to hear...
now i can place shees on the higher platforms and have teles to ge tto them! yay... lol thanx again

Malf · Post by **Malf** » Thu Jul 01, 2004 7:33 am

You spelt Sapien wrong.

HMC Helljumper · Post by **HMC Helljumper** » Thu Jul 01, 2004 1:09 pm

lol i know i was in a hurry... lol

HMC Helljumper · Post by **HMC Helljumper** » Thu Jul 01, 2004 1:10 pm

Malf wrote:You spelt Sapien wrong.

btw u "spelt" "spelled" wrong...

philipks · Post by **philipks** » Fri Jul 02, 2004 8:41 am

you dont need to do any typing. you can put your cursor right over the red z-axis indicator of your scenery to grab it and move it along that axis. you have to put it right on the tip of the red arrow though, if you do it right itll get bigger and a white line will extend to the extents of the universe (well, the sapien universe) to show you where itll go.

Danke · Post by **Danke** » Fri Jul 02, 2004 10:43 am

HMC Helljumper wrote:
Malf wrote:You spelt Sapien wrong.
btw u "spelt" "spelled" wrong...

Actually "spelt" is the British "variation" of the past tense of "spell".