Very deep trouble materiel editing

cplclan · Post by **cplclan** » Sun Feb 03, 2008 5:47 pm

o.k first of all when I add the blue THE splinter map goes down on the ground and 2 top faces not the grey 2nd when I did sorta figure it out only half of it was blue on the top section(faces) and the other 2 top faces are grey and the ground is grey like its supposed 2 be (which I didn't figure out it just happened)
help plz
pics
those 2 r grey

these 2 r blue

Patrickh · Post by **Patrickh** » Sun Feb 03, 2008 6:31 pm

can you explaing your problem in a way that would be easier to understand?

p0lar_bear · Post by **p0lar_bear** » Sun Feb 03, 2008 9:16 pm

Seriously, what? I cannot understand what you're saying; your post is just a bunch of run on thoughts about faces being gray.

cplclan · Post by **cplclan** » Tue Feb 05, 2008 3:49 pm

o.k.. a box has 6 faces and my problem is when I try adding the blue (sky) to the 4 middle faces only 2 of the 6 faces get colored( not top or bottom but 2 in the middle sec.) I think the problem is in the verison (my is 9.0) and maybe editable mesh selection but what really frustrates me is how diff. 9.0 is from all the other versions BS!!!
help plz I'm making a campaign map called the creators it looked good and it was going along fine and I got this new version and it doesn't work!!!wtf

Cryticfarm · Post by **Cryticfarm** » Tue Feb 05, 2008 6:47 pm

cplclan wrote:o.k.. a box has 6 faces and my problem is when I try adding the blue (sky) to the 4 middle faces only 2 of the 6 faces get colored( not top or bottom but 2 in the middle sec.) I think the problem is in the verison (my is 9.0) and maybe editable mesh selection but what really frustrates me is how diff. 9.0 is from all the other versions BS!!!
help plz I'm making a campaign map called the creators it looked good and it was going along fine and I got this new version and it doesn't work!!!wtf

If the versions were the same why make another release? And it should still work.

cplclan · Post by **cplclan** » Fri Feb 08, 2008 1:39 pm

It doesn't freakin' work!!! damn I even reinstalled the damn thing and updated the service packs NOTHING it just doesn't work and I figured that because on version 5 you don't have to check backface cull but on 9.0 u do have to.