LOD remover

Nirvana1214 · Post by **Nirvana1214** » Thu Nov 22, 2007 1:46 pm

i remember for halo 2 there was a program that removed all the Levels of detail except the highest one (5 i think) so no matter where you are, the model will have the highest quality instead of: Low - far away High-close up. I wanted to know if there was a program like this for halo pc.

Philly · Post by **Philly** » Thu Nov 22, 2007 1:49 pm

Look at halopc.net, and there is a plugin for HHT that does just this.

Nirvana1214 · Post by **Nirvana1214** » Thu Nov 22, 2007 2:49 pm

ok thx man, my skins and stuff look like crap unless you're right in front of it....i hope this helps

Edit: i set all of the LODs to 0 except the super high one and it still does the same thing. I cant see all of my skin color unless you're like 10 ft away

Patrickh · Post by **Patrickh** » Thu Nov 22, 2007 3:40 pm

Nirvana1214 wrote:ok thx man, my skins and stuff look like crap unless you're right in front of it....i hope this helps

Edit: i set all of the LODs to 0 except the super high one and it still does the same thing. I cant see all of my skin color unless you're like 10 ft away

are you using photoshop with dds plugins? if so, when you save, and it asks you for the dds settings, make sure you set it to generate mip maps (generate all mip maps). That should fix it...

Philly · Post by **Philly** » Thu Nov 22, 2007 3:56 pm

Yeah, that's skinning, not modelling, my fault. Sorry.

Nirvana1214 · Post by **Nirvana1214** » Thu Nov 22, 2007 4:40 pm

oh yea my question was unclear...but thanks anyway now my models will work good. and patrick its working fine now i set it to generate mips

BOB{MOD} · Post by **BOB{MOD}** » Thu Nov 22, 2007 4:59 pm

i set all of the LODs to 0 except the super high one

no u got to set all of them to 0 or else it wont work...

bcnipod · Post by **bcnipod** » Fri Nov 23, 2007 4:34 am

if your talking about injecting a model you null all but one of the LoD's to get your model to work.