Water Water Everywhere

antszy101 · Post by **antszy101** » Sat Jun 23, 2007 12:20 pm

I added some water to coagulation for a new mod of mine, but the water basically envelopes the two bases on either side of the map. My question is is it possible to have water in only certain parts of the bsp?
any help is appreciated

newbymodder · Post by **newbymodder** » Sat Jun 23, 2007 12:56 pm

yes but u have to lower the water lvl using detox's water tool set it too like 0 then try it then if its too hight or low change it agian till you get it where u want

antszy101 · Post by **antszy101** » Sat Jun 23, 2007 3:21 pm

I used detox's water tool, then fine tuned the water level in entity. I want the water in the center of the map at the level it is at, but because the bases are so much lower than the middle of the map, the water is much higher. I want the water to just be in the middle. Kind of like how the water is only in that cave in coagulation.

McT0asT · Post by **McT0asT** » Sat Jun 23, 2007 3:36 pm

You'll most likely have t fill that section with machines or blocs and give them a water shader. When you add water, you are adding a plane, so its just a straight line of "water".