Cars Drive On Water?

Thrasher Alpha · Post by **Thrasher Alpha** » Fri Jun 15, 2007 4:32 am

Yea, i was going to make a mod by adding some water on coag, then getting a vehicle , model it , skin it , and make it drivable on water. there is no tutorial for this so i was going to ask u guys, lol

Spammy · Post by **Spammy** » Fri Jun 15, 2007 6:23 am

It's semi-possible.

Add your water, and then add a Banshee Barrier at the same height as the water(or a little above).

The only problem is that the vehicle will sink when you get out of it. Also, unless the vehicle is a flying vehicle(Banshee, Pelican...) you won't be able to control it while going over the water.

Thrasher Alpha · Post by **Thrasher Alpha** » Fri Jun 15, 2007 7:52 am

is there any way to make invisible land? u know juke the bareir ur talkin bout

newbymodder · Post by **newbymodder** » Fri Jun 15, 2007 7:57 am

i think if you want you could add the water then just take out all the shaders for the gorund and stuff so its clear then when you drive on land it would really be just invisible ground but with the hills and stuff i dont' think that would work really good its better to just add the barrier and give your vehicles the properites of a banshee then remodel it and raise you water level where you want it

Thrasher Alpha · Post by **Thrasher Alpha** » Fri Jun 15, 2007 8:02 am

Na, i like the idea of sinking. why would you get out in the first place?

newbymodder · Post by **newbymodder** » Fri Jun 15, 2007 8:23 am

no im saying the hills because if you added water then drove over a hill your boat or w/e would be out of the water lol i guess you could add a gate from containment and make it a ramp though

Thrasher Alpha · Post by **Thrasher Alpha** » Fri Jun 15, 2007 8:36 am

Yea. i was going to make the water lvl lower, then made gates.

newbymodder · Post by **newbymodder** » Fri Jun 15, 2007 9:08 am

haha your mod gave me a cool idea i have like 3 maps in progress lol
i think your best bet is adding the barrier for the banshee and making it the same lvl as the water lvl

sunofthenight · Post by **sunofthenight** » Fri Jun 15, 2007 10:49 am

y dont u just skin the ground on coag to look like water, then when u drive oer it itll LOOK like water but u wont sink and have the same manuverability. and the hills will even look like waves??

kibito87 · Post by **kibito87** » Fri Jun 15, 2007 11:01 am

sunofthenight wrote:y dont u just skin the ground on coag to look like water, then when u drive oer it itll LOOK like water but u wont sink and have the same manuverability. and the hills will even look like waves??

Show me how you'd go about skinning the ground of coagulation to look like water? I've seen like 2 people do this and it looked horrid.

Thrasher Alpha · Post by **Thrasher Alpha** » Fri Jun 15, 2007 11:45 am

wat an idiot, why would i want that, I WANT WATER. i dont care if u fall through, i just want water that u can drive on.

Thrasher Alpha · Post by **Thrasher Alpha** » Fri Jun 15, 2007 11:45 am

wat an idiot, why would i want that, I WANT WATER. i dont care if u fall through, i just want water that u can drive on.

newbymodder · Post by **newbymodder** » Fri Jun 15, 2007 5:05 pm

just add the barrier for the banshee skin the banshee to look like w/e then add a death barrier just a little way below that the one from under the map that way if you do lets say get out of fall off u die haha and it'l say killed by the guardians

good idea ? also if you want to have a passanger boat you need that tut on how to add seats i never really understood it but if you mod had like ship to ship fights that would be cool alos if you could board the enemys ship hehe when you release your mod im gona download it no matter what all youv'e done