Lots of UVW Errors... Plz god help me...

inferno · Post by **inferno** » Thu Apr 12, 2007 3:52 pm

How do i fix the blue triangles that indicate UVW errors.

only one word describes how i feel about this... bitchsticks...

D · Post by D » Fri Apr 13, 2007 7:49 am

select all the blue triangles and pull down a uvw map, select box, then modify it however, then right click the map then re convert to editable mesh, you should be set.

inferno · Post by **inferno** » Fri Apr 13, 2007 1:33 pm

sorry could you be a little bit more clear. like can you explain HOW doing this fixes them. so that i can know why the UVW is screwed up when i edit the geometry.

-edit-
cann i just select the entire map cause selecting all those triangles would be a bitch.

-edit 2-
could nearly coplaner surfaces cause a Radiiosity problem?

inferno · Post by **inferno** » Fri Apr 13, 2007 2:22 pm

this sucks ive fixed the UVW perfectly but now Sapien is just locking out when i try too run radiosity. and i mean it is completely locking up it dosent even give me the 0.0000's in the corner.. i have too close it with a end process cause its no responding. but i know i dont have any UVW errors cause sapiens not putting out a debug.wrl