Teleporter adding

smokey · Post by **smokey** » Fri Apr 06, 2007 11:02 pm

I know this sounds a little nubbish, but I need help. I followed Kibito's adding teleporters tut, and everything seemed fine, even in the BSP viewer, but for some reason, when I played it, they were not visible. Any ideas?

xzodia · Post by **xzodia** » Sat Apr 07, 2007 4:15 am

thats because teleporters are invisible, you need to spawn the scenery separately

smokey · Post by **smokey** » Sat Apr 07, 2007 9:09 am

Did he not do that in the tut? I think I remeber doing that in the tut...

kibito87 · Post by **kibito87** » Sat Apr 07, 2007 9:46 am

Yes, I did do that. I cloned 2 chunks in the scenery reflexive so there was the scenery for both the entrance and exit. Although, from what you have told me, you said the objectives themselves didn't work...which is quite odd. I've never run into that before. Try getting a new clean map and redo'ing the tutorial...word for word.

smokey · Post by **smokey** » Sat Apr 07, 2007 1:04 pm

I just deleted all of the chuncks I made, and think I will start over...