modeling help

GKMods · Post by **GKMods** » Mon Jan 08, 2007 5:03 pm

can anyone explain how to use milkshape 3d to remodel halo models???

or just explain how to do any type of modeling???

Shur'Tugal · Post by **Shur'Tugal** » Thu Jan 18, 2007 10:05 pm

well, to use MS3D to rethoutch and existing model yo umust extract it using HMT (see the tutorials forum) and open the resulting file in MS3D. then you may move the EXISTING verticies around to your desire, save it, and import it. it is very important that you do NOT add any verticies or remove any verticies, otehrwise it will not import properly. you should also note that the colision model is effectively un-changeable (unless you have some

GKMods · Post by **GKMods** » Sat Jan 20, 2007 7:18 am

thanks man but is there a plug in needed for milkshape cuz mine wont open the exported halo files.

Shur'Tugal · Post by **Shur'Tugal** » Sat Jan 20, 2007 9:34 am

you cannot directly open them, yo umst use the import function. its ben a while since i've done this, what extension does hte model file have?

GKMods · Post by **GKMods** » Sat Jan 20, 2007 10:40 am

thank u so much it finaly worked and it is wavefront obj.