bsp freezing

srchrisknight · Post by **srchrisknight** » Sun Jun 25, 2006 1:27 am

ok, i've been doing some bsp conversions with entity, and i've come across a problem, on certaint parts of the map, it will freeze when walked on, i've seen conversions where this doesn't happen, so how can i fix this

an example would be on the mambasa bridge, when u walk too far into the tunnel, or when u walk on the black paches

Tural · Post by **Tural** » Sun Jun 25, 2006 3:19 am

Seal off the areas that are beyond where you can access, for the black spots, you need to place the scenery, there's a tutorial in the Entity thread on Files.

srchrisknight · Post by **srchrisknight** » Sun Jun 25, 2006 9:10 am

ok, but in the high 9 bsp, on either side of the little room there is a freezing point, its too small to seal off, so wat do i do there