Collision Model Tutorial. . .

HunterXI · Post by **HunterXI** » Sat Feb 28, 2004 11:31 am

u can use calc to calculate hex? or do you have to change it to a raw number first, then back?

Ang88 · Post by **Ang88** » Sat Feb 28, 2004 11:49 am

when i tried it with computers calculator it didn't give me the numbers that he said in his turorial

XeRoWaVe · Post by **XeRoWaVe** » Sat Feb 28, 2004 11:55 am

ok go to ur computers calc. go under View then hit Scientific then hit Hex put the offset in then i think hit dec it should b in number form i think this is right now multiply it by 5 then hit hex again i think thats how

HunterXI · Post by **HunterXI** » Sat Feb 28, 2004 11:58 am

XeRoWaVe wrote:ok go to ur computers calc. go under View then hit Scientific then hit Hex put the offset in then i think hit dec it should b in number form i think this is right now multiply it by 5 then hit hex again i think thats how

oh lol, I really should've figured that out...

XeRoWaVe · Post by **XeRoWaVe** » Sat Feb 28, 2004 12:09 pm

wait no its in float so its different u cant multiply just the doubleword hex by 5.... need to get its float value which he said was at the bottom of hex workshop

lets see here i htink 2359 in float sumtin around there is about 5.00

HunterXI · Post by **HunterXI** » Sat Feb 28, 2004 12:11 pm

XeRoWaVe wrote:wait no its in float so its different u cant multiply just the doubleword hex by 5.... need to get its float value which he said was at the bottom of hex workshop

lets see here i htink 2359 in float sumtin around there is about 5.00

haha lol... slip up a little?

j/k

kingo · Post by **kingo** » Fri Mar 12, 2004 2:35 pm

Thanks for the tutorial. It helped me alot.

bob10 · Post by **bob10** » Sat Mar 13, 2004 7:54 am

thanx for the tut but how do u change the model to say, a metal panel?