Active Scenery Please Help

XxD3ATHxX · Post by **XxD3ATHxX** » Sat Jun 24, 2006 1:59 am

Ok is there a way to figure out the Yaw, Pitch, and Roll of a pelican. I thought you could just move it how you wanted in Entity but when I do that, it is not the way I put it in Entity. The X, Y, and Z cordinates are fine. It's just the Yaw, Pitch and Roll. I dont understand because in Entity's BSP viewer I see the pelican and I position it just how I want it but when I load my map, it goes in a different direction and it is turned different too. If anyone knows anything on how to fix this please lemme know.

Monkey Terd · Post by **Monkey Terd** » Sat Jun 24, 2006 5:32 am

Entity's rotation setting is off...either do it manually, or use Darkmatter.

cherabum · Post by **cherabum** » Sat Jun 24, 2006 6:58 am

the easiest way is to right after you open you map in darkmatter/H2x and do the thing and change the spawn time is to save the map open your coord finder and look at the spawn point ....then open entity and click visible collections and their it is...move as wanted........