Very easy Spark edit question! 30 seconds to read and answer
-
mod master
- Posts: 142
- Joined: Sat Aug 28, 2004 3:27 am
- Location: Help! I'm in a vent!
Very easy Spark edit question! 30 seconds to read and answer
Ok i'm making a warthog race map in blood gulch and i'm using those little blinking lights as the track. On spark edit I swapped a piece of scenery for them, made a straight line of them and tested it and found that there were only about 3 red and 3 blue lights in the line!!!
Please tell me what is wrong!!! 
MrChief wrote:343 looks like a disco ball in that pic.
-
mod master
- Posts: 142
- Joined: Sat Aug 28, 2004 3:27 am
- Location: Help! I'm in a vent!
-
mod master
- Posts: 142
- Joined: Sat Aug 28, 2004 3:27 am
- Location: Help! I'm in a vent!
Check to make sure you're not placing them too low into the map, they will fall through.
http://www.customcrysis.com Crysis mapping / modding site under development.
-
mod master
- Posts: 142
- Joined: Sat Aug 28, 2004 3:27 am
- Location: Help! I'm in a vent!
Well, they don't fall through. They just won't appear. I suggest you place them a little extra high just in case. And don't forget to save the map! If you built 3 beacons then saved, then built the rest and forogt to save then yeah....mod master wrote:Well they don't move. If you place them to high they float so i'm guessing thats not itDECOY wrote:Check to make sure you're not placing them too low into the map, they will fall through.
I've actually done what you're doing now, except it was more of a remodelled banshee/hog I used as race cars. It works for me...maybe you're just not doing this correctly.

-
mod master
- Posts: 142
- Joined: Sat Aug 28, 2004 3:27 am
- Location: Help! I'm in a vent!
- Ketchup_Bomb
- Posts: 3374
- Joined: Thu Mar 18, 2004 7:52 pm
- Location: ¯\ ( º _ o ) /¯
- Contact:
|
|
|
|
|
|
|
|
|
|
-
mod master
- Posts: 142
- Joined: Sat Aug 28, 2004 3:27 am
- Location: Help! I'm in a vent!

