1280x1024 Party Grunts!
Render Gallery Submission Thread (Updated 8-13) 56k warning
-
xplosivteam
- Posts: 67
- Joined: Tue Feb 15, 2005 6:55 am
- TheTyckoMan
- Posts: 854
- Joined: Fri Apr 02, 2004 11:22 am
- Location: Tea co not Tie co...
|
|
|
|
|
yeah...seriously....geez man what the hells wrong with you? back ontopic...Lavix wrote:If you up the size of his font then you can see how off topic his post really is. Thats really inappropriate.Xero wrote:The shield looks nice.![]()
I sleep in the nude.
i love jackals! try not to make it SO bright...a lil bit but not enough the jackal shields were bright but not THAT bright...im sure that would blind the elites.

Thanks LT.
New ODST fire team render:

Any comments welcome

Any comments welcome
Try setting the brightness halfway in between the two settings you showed. Also try adding a dim omni light (or a whole array) to it. That might give a good glow effect but you might want to set them to exclude the shield for illumination and or shadow casting.Please say whether or not you like the shield better with or without the glow
looks good, except for one thing that i think should've been obvious to you. the sniper's left hand is not positioned correctly. he needs to grasp the rifle, not balance the rifle on the clip in his palm.
Dude. No. Do you even know who Katarn and Snaf are?They are some of the few 1337est modelers that have ever set foot in CE. =D
-
Halo 2 Rules!!
- Posts: 346
- Joined: Mon Mar 22, 2004 1:16 pm
|
|
Actually I did that on purpose. Shooters often use that hold on rifles to bring the rifle up higher I used it because it seemed like the best hold for this rifle due to a few reasons. The first being that if I put him in a pose where he was holding in in between his thumb and index finger on his palm as I would for a normal rifle, his hand would be farther forward to clear the mad and would lower the rifle's muzzle. As you can see the muzzle is already too low because I had to raise the rear to get good uh... "Helmet weld". If the muzzle was lowered I would have to raise his elbow off his hip, normally I would do that but due to the size of that rifle (especially the huge barrel) and my experience with rifles I would say that that rifle would be VERY heavy, like 20 or 30 or more pounds. Not a very big problem for a seven foot tall half ton cyborg super soldier who can flip a 66 ton tank with his bare hands BUT for a little (relatively speaking) ODST this could cause a lot of fatigue. The visors are welded that is just the corner of the box they are standing inlooks good, except for one thing that i think should've been obvious to you. the sniper's left hand is not positioned correctly. he needs to grasp the rifle, not balance the rifle on the clip in his palm.
That said, I think I will tweak the pose a little. Also I don't want to be accused of spamming so here is a picture my friend had me make while he was over this after noon. ODSTs on a LONG patrol.

Now I need to get a towel to wipe all the drool off my desk from looking at Halo 2 Rules post
Chest plate on the first one looks kind of.. pointy.Halo 2 Rules!! wrote: http://img344.imageshack.us/img344/2184/yay22km.jpg
http://img344.imageshack.us/img344/8338/f8he.jpg[/img]
http://img365.imageshack.us/img365/1685 ... ing4ki.jpg
decided to make some changes. still needs work









