Ok, here's the problem I ran into last night. As I finally figured out how to edit the models in Milshape, I was trying to rework the Assult Rifle. Now I got the 2 low-detail models edited and injected fine, so I have had somewhat limited success. My problem came when I tried to inject the 3rd(high detail). When injecting, I got the too many verticies error. But the guidlines I was following was that I could not delete or add objects, which I didn't. I did however move some things quite drastically. Could this add verticies, because I assumed moving does not create anything. I'm going to try to redo the model again, because maybe I did something wrong by mistake. Anyone run into the problem like this injecting a model before?
Thx,
__Blaz0__