Need help with PMI!!! URGENT

nsilva · Post by **nsilva** » Sun Feb 05, 2006 12:12 pm

Im trying to PMI ive done it many times before but the last 4 times i tried the things screwed up...

I PMI and then the bitmaps screw up..

The things flip outta control and scenery and vehicles just dissapear i dont know whats wrong herre is an images of one of them

Anyone know whats wrong

ShadowSpartan · Post by **ShadowSpartan** » Sun Feb 05, 2006 7:52 pm

This has happened to me before. Did you remember to copy the [map name here].sbsp.META and paste it in the levels/test/bloodgulch folder, overwriting the old one? That is probably your problem.

-ShadowSpartan

Kurroda · Post by **Kurroda** » Mon Feb 06, 2006 5:57 am

just figure out what your doing wrong you said you have done it right before

Grave · Post by **Grave** » Tue Feb 07, 2006 8:45 am

you probly screwed up something in the PMI process go back and do it over and make sure you do everything right thats what i do when i screw up

Kurroda · Post by **Kurroda** » Tue Feb 07, 2006 10:17 am

you just got to do it over and over again till you get it right

mustard_pudding · Post by **mustard_pudding** » Tue Feb 07, 2006 12:42 pm

ShadowSpartan wrote:This has happened to me before. Did you remember to copy the [map name here].sbsp.META and paste it in the levels/test/bloodgulch folder, overwriting the old one? That is probably your problem.

-ShadowSpartan

yes, i have had that problem in the past. its one of the most important things in the whole process as small as it seems...its quite easy to forget until youve had a lot of practice with pmi