milkshape modeling

argrn · Post by **argrn** » Sat Feb 14, 2004 9:59 am

i export the model from hmt then i edit it by just clicking verticies and dragging them to a new spot. i think that im not making any new ones but i am? because when i try to inject it it says there is more verticies or indicies?

Floyd · Post by **Floyd** » Sat Feb 14, 2004 10:00 am

In MilkShape just press F1 to select and then once selected press F2 to move them.

You shouldn't have any problems if you don't delete or add.

Demonic Spartan · Post by **Demonic Spartan** » Sat Feb 14, 2004 10:00 am

You have to select by vertex, extrude or move the vertex. You can't select by anything else.

TsukasaZero · Post by **TsukasaZero** » Sat Feb 14, 2004 10:01 am

Oh...thats why my models never import....

Floyd · Post by **Floyd** » Sat Feb 14, 2004 10:04 am

Also, I found it makes it easier if you uncheck "Ignore Backfacing."

argrn · Post by **argrn** » Sat Feb 14, 2004 10:04 am

ok it imported but when i open halo and tested it the pistol on the ground was my new model but the one in my had was the regular. do i have to change another model for my hand?

Beastman · Post by **Beastman** » Sat Feb 14, 2004 10:27 am

yes, there is a first person model and third u did the third, ignore backfacing can screw u up so watch out, its for if u want to do not want to pick vertcies on the other side of the model, but if u want something semetrical u need to have that unchecked.

Icetiger · Post by **Icetiger** » Sat Feb 14, 2004 10:28 am

You have to change all the version of the model to make it look right from all distances.

argrn · Post by **argrn** » Sat Feb 14, 2004 10:30 am

ohhhh i see if i change them all will it look like my model when the guns in my hand?

Beastman · Post by **Beastman** » Sat Feb 14, 2004 10:33 am

if u change the first person model the one that says fp after it

argrn · Post by **argrn** » Sat Feb 14, 2004 10:36 am

ok i was about to ask about the fp one thanks everyone