Page 1 of 1
Model Injection. I need help.
Posted: Mon Mar 31, 2008 11:39 am
by BattleSkarz
I recently decided to finally tackle the monstrous task that is 3d modelling for halo. I found a tutorial on it, made a relatively simple weapon model to replace the BR, a Lancer, and scaled it corectly and everything. (in 3dsMax) Now, when I tried to inject it using entity, I get an error message (Below) What did I do wrong?
An extremely obnoxious render of my Lancer
Posted: Mon Mar 31, 2008 11:44 am
by plushiefire
Posted: Mon Mar 31, 2008 11:54 am
by BattleSkarz
ok, i guess i can try that one too, although its very similar to the other two I used. I would really like to know what that error means though...
Posted: Mon Mar 31, 2008 1:14 pm
by mr_penguin
Maybe your model has too many faces. And try opening it with misfit model 3d and then resaving it as the same thing and do that for each one. I've noticed 3dsmax obj saves don't work half the time when injecting but if you resave it in a different app then it normally works.
Posted: Mon Mar 31, 2008 9:42 pm
by SkgSkrillaka
hmmm..
Sometimes when your using a map and you accidently clcik something wrong it comes up with an error
that you would understand
but then everything starts screwing up
Has that happened with the map your modding?
just a thought
answers above ^ are also correct
Posted: Tue Apr 15, 2008 12:13 pm
by BattleSkarz
plushiefire's tut didn't help, and i somehow doubt it has too many faces, I think its actually a smaller file than the br. Also, what is misfit 3d? i can has link?
Posted: Tue Apr 15, 2008 12:20 pm
by Eaton
BattleSkarz wrote:plushiefire's tut didn't help, and i somehow doubt it has too many faces, I think its actually a smaller file than the br. Also, what is misfit 3d? i can has link?
It's another 3d Modeling program.
http://www.misfitcode.com/misfitmodel3d/
Also, try injecting the model with a different application, such as DarkMatter.
Posted: Tue Apr 15, 2008 12:35 pm
by DarkShallFall
Make sure that you renamed your model to the extracted one. Also make sure the .mtl file you are injection is the exact same thing that was extracted.
Posted: Thu Apr 17, 2008 3:11 pm
by BattleSkarz
@Darkshellfall
That .mtl thing might be it...
@Eaton
Darkmatter fucked the hell out of the map when I used it.
Posted: Sat Apr 19, 2008 9:30 am
by BattleSkarz
Upon further investigation I found that my lancer file is almost twice the size of the br. Could be an issue.
Posted: Tue Apr 22, 2008 5:15 pm
by Dragonfire
hmmm, im not sure...
Posted: Tue Apr 22, 2008 5:51 pm
by Eaton
I've seen that error message a few times and that is most likely a map error. Have you tried taking a CLEAN map and injecting it?