Question on Sniper Model import

Scoliosis · Post by **Scoliosis** » Thu Aug 03, 2006 5:47 pm

when i edit the sniper model to my liking and then import it back into the map as a new model. The sniper screen is screwed up. Its all distorted, Why is that? I didnt make any changes to the screen so i dont see why that would happen.

a mammoth · Post by **a mammoth** » Thu Aug 03, 2006 6:21 pm

did you use dark matter, becuase dark matter screws the UVWs over.

Scoliosis · Post by **Scoliosis** » Thu Aug 03, 2006 6:28 pm

nope used entity. I was testing it cause iv been trying to get the sniper screen on a new model of mine. I did it with the BR numbers the exact same way but the screen is alot harder. The texture remains fine but the screen is screwy. ill take a pic and upload it in a few minutes

http://putfile.com/pic.php?pic=main/8/2 ... .jpg&s=f10

if the screen was working correctly i could see that warthog but i cant. its distorting the image.

edit: wow this post just made me a jackal lol

Doom · Post by **Doom** » Fri Aug 04, 2006 6:00 pm

it could be the placemeant on the model =\. Not sure about it though. Try leaving it in the same place as the orignal one on the new model and see what happens.

-Doom

Scoliosis · Post by **Scoliosis** » Fri Aug 04, 2006 7:12 pm

k i tried that it it didnt work. I only changed the length of the barrel so i could confirm ingame that the model changed. IOt didnt work. Its still distorted

a mammoth · Post by **a mammoth** » Sun Aug 06, 2006 1:13 pm

It might be something with what texture goes where, that either milkshape or entity is screwing up, try extracting the modle then just doing a straight import for the extracted thing.