Page 1 of 1
Entity gives me an error when BSP editing.
Posted: Tue Jul 25, 2006 12:53 pm
by crap box
I have .net framework 2.0 so the program loads fine. Then when i try to load the BSP editor it says "Specified module could not be found."
This is on my new computer.
Posted: Tue Jul 25, 2006 1:37 pm
by llamamastafu
it may be your version of entity, this happens in 1.1.7 for me.
Posted: Tue Jul 25, 2006 1:45 pm
by dos mes
Yes, the newer version for somereason has problems with the bsp viewer. Download an older version like 1.1.6 or 1.1.5 and then try.
Posted: Tue Jul 25, 2006 3:30 pm
by UntoldLegendxx
just stick to 1.1.6 that doesn't do that problem
Posted: Tue Jul 25, 2006 4:27 pm
by crap box
that sucks, it was working on my old computer.
Posted: Tue Jul 25, 2006 4:40 pm
by crap box
1.1.6 doesnt work either, with any maps. WTF?
Posted: Tue Jul 25, 2006 6:27 pm
by Boney526
Ya some people have that problem with 1.1.6 go for 1.1.5 or if you need to 1 or maybe Alpha 1. Lol i think 1.1.5 should be fine though.
Posted: Tue Jul 25, 2006 6:38 pm
by UntoldLegendxx
if that one does it to it may be your gfx card or direct x i thought i heard some1 say.
Posted: Tue Jul 25, 2006 9:56 pm
by crap box
thanks, i did need dirext x.
Posted: Tue Jul 25, 2006 11:03 pm
by UntoldLegendxx
I take it it works now?
Posted: Wed Jul 26, 2006 1:03 am
by crap box
yeah after i got direct x it works. However, when i put my pc to 1024x768 and then check "collection" the BSPeditor freezes. Im assuming this is because im using onboard video.
Posted: Wed Jul 26, 2006 8:27 am
by UntoldLegendxx
It could be but then i have onboard and my computer runs it fine so i dont know
Posted: Wed Jul 26, 2006 10:41 am
by crap box
Sorry, I said it freezes but my pc actually restarts. When it reboots it said the computer has restarted due to a driver error.