BSP Editing: Success! Collision: Failure

Fantom13 · Post by **Fantom13** » Tue Nov 29, 2005 4:03 pm

I successfully put a hole in the ground in Backwash as a test , but the collision is still intact. (in other words, I float right over the hole as if ground were there). Any idea's on how to fix the collision?

mrhyperpenguin · Post by **mrhyperpenguin** » Tue Nov 29, 2005 6:36 pm

the collison verts are supposvely in the bsp. i modeled these and didnt look like it was supposed to but heres the data anyways. by the way, is there any documentation on the visual bsp mesh that you used? i tried usuing the darkmatter source but i cant understand pokes code when it comes to the bsp and models.

http://angrycamel.com/hxbdev//forum/vie ... 6&start=31

thanks the swampfox

lxNicktardxl · Post by **lxNicktardxl** » Tue Nov 29, 2005 6:59 pm

How did you even get a hole in the ground?

lol.

Shalted · Post by **Shalted** » Tue Nov 29, 2005 7:55 pm

Modified, BSP Model. The BSP's collision is at another (BSP) Reflexive in the SBSP tag... I cant remember which one( should be floating around on the hxbdev mirror)... Theres something else you have to edit too... I cant remember what that is either... Oh well, you can figure it out..

Dyer13 · Post by **Dyer13** » Fri Dec 02, 2005 3:26 pm

how do you edit the bsp map? I want to add/clone/move water in zanzi and I dont know how..I exported the map using DM, it is an .obj, and how do I inject it back in?If this is totally wrong, how do I do it?

Talin64 · Post by **Talin64** » Wed Dec 07, 2005 7:20 am

sbsp editing is tough. You will have to figure out the whole tag before even trying to edit it. I know you can't just export the tag to obj edit it and reimport.
Good luck Talin