Page 1 of 1
Water
Posted: Sat Jun 26, 2004 6:09 pm
by TheMissingLink117
The map that I am working on is one island surrounded by an ocean. In 3ds max I made the ocean plane pretty large (16000 by 16000), so that It would extend out of the skybox like it does in Death Island and Blood Islands, but when I open the level in Sapien, the water plane stops where the skybox end. Also the .fog tag I created is not showing up under the water in sapien. I have it in the tags\levels\test\mylevel directory. Could anyone help me?
Posted: Sat Jun 26, 2004 6:32 pm
by HMC Helljumper
I don't think that the Death Island water goes beyond the skybox. I believe that the level is actaully that big, otherwise you would not be able to get throught the barrier. I think thhat the barrier is actually player clipping, which is talked about in the original HEK tutorial. I do not know how to do player clipping, but if I figure it out I will let you know.
That's my two-cents worth. Correct me if I am wrong.
Posted: Sat Jun 26, 2004 6:37 pm
by TheMissingLink117
Thanks, I do know how to player clip, its pretty easy if you follow the HEK tut.
Posted: Sat Jun 26, 2004 7:17 pm
by HMC Helljumper
ok.. does anyone know how to run radiosity in tool? sry for off topic.. i just didnt wanna make another thread...
Posted: Sat Jun 26, 2004 7:20 pm
by Burnination
Posted: Sat Jun 26, 2004 7:43 pm
by HMC Helljumper
thx.. but then how do i save the radiosity in tool? or is that possible?