How do I do an under water base?

Hyperdash · Post by **Hyperdash** » Sun Mar 19, 2006 3:40 pm

Well? and by that I mean that there is water around your base but not inside it.

tabasco sauce · Post by **tabasco sauce** » Sun Mar 19, 2006 4:40 pm

hmmm try making a model around the base then giving it the !water shader

Patrickssj6 · Post by **Patrickssj6** » Sun Mar 19, 2006 5:48 pm

Would look ugly without foq and with foq it would go through the base.So basically impossible I think.

p0lar_bear · Post by **p0lar_bear** » Sun Mar 19, 2006 7:37 pm

YOu could try making the base model, then put it under a water/fog plane. Then on the underside of the base where the entrance would be, put another fog/water plane. Not sure how it would turn out, though you should most definitely use a sky that doesn't have atmospheric fog. When atmospheric fog and plane fog collide, anything under thew fog plane become totally opaque.

Caboose{SE} · Post by **Caboose{SE}** » Mon Mar 20, 2006 5:00 pm

wish i knew that a while ago : /