Page 1 of 1
tool help
Posted: Sat Sep 04, 2004 5:16 pm
by clutch152
when i open tool it opens for a split second to reveal that it "cannot read './toolbeta.map" or something to that extent then it closes imediatly thereafter. can anyone tell me what is wrong?
Posted: Mon Sep 06, 2004 1:09 pm
by Haloman1337
I'm pretty sure you have to open tool from command prompt, not by just clicking on tool.exe. However any tutorial could tell you better than I can. Good luck.
Posted: Mon Sep 06, 2004 4:25 pm
by kaptainkommie
He is correct. You must run tool from the command prompt (cmd.exe).
Posted: Tue Sep 07, 2004 11:18 am
by Captain_Lag
toolbeta.map thing you can ignore when you compile anything