haloce prob

[mxjf2]

when i run tool build-cache-file levels\hill\hill i makes the map and even puts it in the maps folder, i checked. but when i run haloce it doesn't show up in the list.

[[CL]9mm-Man]

I had that problem before, I dunno exactly how I redid it. But you have some errors, try making the structure again, or re do the map.

[mxjf2]

when i run tool sucture levels\hill hill it says this twice

### warning: a surface clipped to no leaves <see cyan in error geometry>

[[users]axem]

It gives a sample of that in the hek error thing in the hek tut.

This is a problem caused by the implementation of the portal planes and geometry.

This can be caused by geometry that has a face which is coplanar with the faces of another piece of geometry.

A good example would be a cube that has a face resting on the faces of another surface (such as a floor). In this case, an error may not have occurred before, but once portals are added or defined the portal calculations during the compilation process detects the error since it cannot properly create a portal between the two pieces of geometry.

In the above example, there are two solutions. The cube can be moved such that it no longer has its bottom faces resting on the faces of the other surface. The other solution is that the cube should have its bottom faces removed and the remaining faces should be properly integrated with the surrounding faces.

[mxjf2]

ok ill try that.

[an emu]

dont ask that here... u better edit your post. if you want to know that kind of stuff ask at another site