HaloMods "Classic" Read-only Archive

ok, so i've been working on a plasma pistol remodel and i was able to export the model, then import the edited model, then play with it in halo, but then i remembered that i had to switch the 3rd person model for the first person model, so i do that, then all of a sudden it gives an exception. so i close HMT, then start it up again, go to plasma_pistol_fp, then it brings up this:
so then i just replace the old map with a backup, then i open it in HMT open plasma_pistol_fp again, same thing... WTF

Only inject the model into the first person, then use hht to swap out the 3p

Umm, that happens sometimes. Retry injecting it with a fresh map.

DeadHamster wrote:Umm, that happens sometimes. Retry injecting it with a fresh map.

that is a fresh map, i haven't injected it into a fresh map yet because of that exception.

guysullavin wrote: that is a fresh map, i haven't injected it into a fresh map yet because of that exception.

He's saying GET a fresh / unmodded map and inject to that.

also try redoing the remodel if that helps

MoDFox wrote:

guysullavin wrote: that is a fresh map, i haven't injected it into a fresh map yet because of that exception.

He's saying GET a fresh / unmodded map and inject to that.

i cant, because every tiem i open a fresh bloodgulch.map then select plasmapistol_fp it gives the exception, i cant inject it

If you are using an un-edited map and it is giving you an error, there is something wrong with the program.

xbox wrote:If you are using an un-edited map and it is giving you an error, there is something wrong with the program.

bingo, plus i've tried re-installing it too, but it still ahs the same problem >_> and its not liek its otehr maps eitehr, its just any bloodgulch on the plasmapistol_fp model, i mean the normal model is fine, but the FP is messed up.