HaloMods "Classic" Read-only Archive

How do I inject scenery?

I've followed that PMI Simplified tutorial and the one on Pepness.net, just replaced Pelican/Wraith with the scenery and done everything with no errors popping up except that while rebuilding it, I don't get a popup asking me to load the offsets. When I open the map in SparkEdit, the scenery is there, but when I swap it, SparkEdit gets an error and stops working, then closes. Tried loading the map ingame, and of course, Gather Exceptions...

Any ideas with what I'm doing wrong?

You're not moving the new map.sbsp file you got from decrapping the models to levels/test/map/

try that

or, you're not decrapping them at all, bt its most likely the first thing

Ajax17 wrote:while rebuilding it, I don't get a popup asking me to load the offsets

You're not meant to. Read the tutorial again and follow it properly next time. If you can't follow a tutorial, don't bother asking questions.

27. When it asks if it should update the starting offset, click YES!

am i supposed to be using this tutorial and just replacing the peli with the scen?

pretty much yes.