Page 1 of 1
exception data
Posted: Sun May 02, 2004 11:08 am
by riacharda
hi i'm new around here and i'm a bit familiar of how to apply mods using PPF-O-Matic. i downloaded ANIB1.1 and i used PPF-O-Matic to apply it. when i loaded bloodgulch it said Exception! Gathering Exception data. and it couldn't load. what should i do?
Posted: Sun May 02, 2004 11:45 am
by HoboRockAssassin
u just applied it wrong
read a tut u probably mixed up the map and the ppf patch in the two spots of the ppf-omatic
Posted: Sun May 02, 2004 12:17 pm
by MasterNeoChief
Remember Exception error well.
You'll see it ALOT.
People refer it to MR. exception.
Posted: Sun May 02, 2004 7:34 pm
by rossmum
MasterNeoChief wrote:You'll see it ALOT.
Yeah, especially if you're like me.
Posted: Tue May 04, 2004 3:43 am
by riacharda
i'm sure i checked the place where i apply ANIB1.1. i put it on the patch section(bottom collumn) and Bloodgulch.map on topcolumn.
Posted: Tue May 04, 2004 5:25 am
by MasterNeoChief
Yes, under ISO the map goes, and patch is ppf.
it happened to me when i started.
Posted: Thu May 06, 2004 5:23 pm
by moch230
are you sure you are familliar to the ppf o matic? The top bar is for the original map file. The bottom is for the patch. If you have bg on top you have to add a bg file on the bottom. If you have bitmaps on top you have a new bitmaps on the bottom. Basically you have to have a matching patch.
