Page 1 of 1
I think the problem is with the bsp...
Posted: Tue Apr 27, 2004 2:21 pm
by Trexnumber1
I have converted both b30_a and b40_b. when they are all done rebuilding and i open them in sparkedit, under the navigate tab there is the bsp list. In both my conversions it is blank. the weird thing is that both maps load and are visible but i can't select any objects and the viewing screen is flickering. what have i done wrong???? i have searched the forums but found nothing. thanks for all your help
Posted: Wed Apr 28, 2004 2:05 pm
by frozenflames
the flickering(for me) happens when i have too many things open. Try closing some stuff. About the not being able to select, make sure your in the right mode. If you are, try rebooting the comp and first thing open SE and edit ur map b4 anything else.
The absence of a bsp is a common occurance. Dont worry.
Posted: Wed Apr 28, 2004 2:10 pm
by {IAS}Bunkerking
u converted them into the same map?
Posted: Wed Apr 28, 2004 2:34 pm
by maegus15
Nothing pops up on the Seleact thing, because when rebuilding the Unicode strings get screwed for some reason.
Posted: Wed Apr 28, 2004 5:10 pm
by {IAS}Bunkerking
ya nobody can fix that..maby mono
Posted: Wed Apr 28, 2004 7:39 pm
by HunterXI
try reDLing 3.5 and be sure to get the update.
Posted: Thu Apr 29, 2004 5:20 am
by VGChampion
Or are you talking about there are no models shown? Because I have had that happen a couple of times, where the map was converted but none of the models showed up...
Posted: Thu Apr 29, 2004 6:43 am
by maegus15
I just keep swaping intill I find the right (Say senery) I want.
Posted: Thu Apr 29, 2004 1:40 pm
by Trexnumber1
it's so weird it is still flickering but i can only select certain spawn points is that normal? it's kinda annoying. thanks for your help