Page 1 of 1
error with sound file swap
Posted: Fri Jul 20, 2007 10:06 am
by Impreza
so i used gold wave to edit a sound effect from an old star wars game i have lying around (X-wing vs Tie) since it was a wav file. i switched it to a one channel mono mixed sound (one channel) and saved as xbox codec 22.05 whatever (same as pistol) and successfully imported it. but when i tried it. it was completely messed up. did not sound anything like the sound effect i wanted. If someone could help me figure out whats wrong, i'd be very grateful. PM me for the sound file i imported into halo, edit with gold wave if you have it. thanks everyone.
Posted: Fri Jul 20, 2007 10:14 am
by Patrickh
make sure the sound is the same size or slightly larger.
I f you need to put in a smallyer sound, add in abunch of empty space after the sound so that it's slightly larger than the one you're injecting over
Posted: Fri Jul 20, 2007 10:17 am
by Impreza
hmm, thanks ill check that, i may have forgotten about that rule, thanks, ill see if that fixes it.
thanks it worked, sounds pretty good, a little muffled though, but the main thing is that it works, thanks pat
Posted: Fri Jul 20, 2007 10:48 am
by Impreza
.
Posted: Fri Jul 20, 2007 10:55 am
by Patrickh
Impreza wrote:.
?
your welcome
Posted: Fri Jul 20, 2007 12:40 pm
by Impreza
Impreza wrote:.
must have been a glitch. never typed that. thanks again pat!
one problem ive noticed, its not very clear sounding, but when run through gold wave, sounds crystal clear, any ideas?