error with sound file swap

Impreza · Post by **Impreza** » Fri Jul 20, 2007 10:06 am

so i used gold wave to edit a sound effect from an old star wars game i have lying around (X-wing vs Tie) since it was a wav file. i switched it to a one channel mono mixed sound (one channel) and saved as xbox codec 22.05 whatever (same as pistol) and successfully imported it. but when i tried it. it was completely messed up. did not sound anything like the sound effect i wanted. If someone could help me figure out whats wrong, i'd be very grateful. PM me for the sound file i imported into halo, edit with gold wave if you have it. thanks everyone.

Patrickh · Post by **Patrickh** » Fri Jul 20, 2007 10:14 am

make sure the sound is the same size or slightly larger.
I f you need to put in a smallyer sound, add in abunch of empty space after the sound so that it's slightly larger than the one you're injecting over

Impreza · Post by **Impreza** » Fri Jul 20, 2007 10:17 am

hmm, thanks ill check that, i may have forgotten about that rule, thanks, ill see if that fixes it.

thanks it worked, sounds pretty good, a little muffled though, but the main thing is that it works, thanks pat

Impreza · Post by **Impreza** » Fri Jul 20, 2007 10:48 am

Patrickh · Post by **Patrickh** » Fri Jul 20, 2007 10:55 am

Impreza wrote:.

?

your welcome

Impreza · Post by **Impreza** » Fri Jul 20, 2007 12:40 pm

Impreza wrote:.

must have been a glitch. never typed that. thanks again pat!

one problem ive noticed, its not very clear sounding, but when run through gold wave, sounds crystal clear, any ideas?