HaloMods "Classic" Read-only Archive

ok i am following this tutorial http://halopc.net/phpBB2/viewtopic.php?t=105 and for the de-crapper i put in the mod2 and it says raw vertexies not found what did i do wrong

you need to extract the raw model form the CVS file

i did stupid PMI its evil

then you didnt extract the m to the right folder.

well then im making a good tutorial that actually works cause i have tried 5 and none have completely worked

or maybe you cant follow a tutorial

im not stupid

if you cant follow a tutorial then yes you are.

link me to these so called "incomplete tutorials"

k ill do all of them again exactly as they say and they dont work

Ok. without implying stupidity on anyone, its not really likely that I would
host a site full of PMI tutorials that dont work......

The most common error for file placement is the fact that when you
recursively extract the item you only select the outer most folder and
HMT creates the sub folder tree.

However, when you extract the raw model from the CSV file you MUST go
into the the folder tree to the exact folder required. This is not as hard as
it sounds. If you take a few seconds and look at the item listed in the CSV
file, it actually tells you inthe file which section of the folder tree and the
exact directory to put it in.

If you get an error message of verice and indice not found, you need to
pause the PMI process right there. Locate the missing indice and vertice
files and move them into the correct folder. You can then call the decrap
popup and try again.

can you put a PMI into a SP level? when im rebuilding it says cannot locate file blah/blah/blah/blah/a10.sbsp.meta and the file is right in the stupid directory.

you have to rename the sbsp.meta

arrggg geez theres tons of tutoral in other sites too u know

Zenaku213 wrote:you have to rename the sbsp.meta

change it to... ill look it up but now im half asleep and if you mean to what it said in the error than it is what it said in the error and where do you put the renamed file? sry but im half asleep and cant think striaght dont you put it on the bottom where it says add when rebuilding map along with the object your injecting?

what is the c:\buildtree.txt? when i try to rebuild my map it says can not access file c:\buildtree.txt it is being used by another program.

That error is typically associated with two sessions of HMT running while you attempt to rebuild. Go into Processes and end HaloMapTools.exe there. Then continue the rebuild.