.map to .ppf?

AbeFroman · Post by **AbeFroman** » Wed May 04, 2005 8:41 pm

how do you make a ppf from a map file?
edit: i just dled ppf studio and i have no clue what to do in it

shanetje · Post by **shanetje** » Thu May 05, 2005 2:18 am

next to ppf (output) click on the map thing and typ in a name you want for it and click open

at original file you open the original map and at patched file you open your modded map then click crate ppf-patch and you have to wait untill the status logfile will show the message ready found ...... differences

AbeFroman · Post by **AbeFroman** » Thu May 05, 2005 6:40 am

i tried, it says "no ppf location or something specified"

MasterNeoChief · Post by **MasterNeoChief** » Thu May 05, 2005 7:48 am

You have to set a place where you want to save the ppf file to

Note: YOu have to put .ppf after the filename.

AbeFroman · Post by **AbeFroman** » Thu May 05, 2005 3:00 pm

once again...i tried, at the LOWER SECTION WHERE IT SAY'S "ppf patch location...i tried to open the one that just got automatically created by the first step and it said failed to load the file
edit: o wait i think i got it now, it says when load origional file (untouched map) so im thinkin, extract all the sp cab files and use THOSE as the original file and the modded one as the patched, ok i understand now