Inject Scenery?

ajax17 · Post by **ajax17** » Fri Jan 04, 2008 9:39 pm

How do I inject scenery?

I've followed that PMI Simplified tutorial and the one on Pepness.net, just replaced Pelican/Wraith with the scenery and done everything with no errors popping up except that while rebuilding it, I don't get a popup asking me to load the offsets. When I open the map in SparkEdit, the scenery is there, but when I swap it, SparkEdit gets an error and stops working, then closes. Tried loading the map ingame, and of course, Gather Exceptions...

Any ideas with what I'm doing wrong?

SL!P · Post by **SL!P** » Sat Jan 05, 2008 5:09 am

You're not moving the new map.sbsp file you got from decrapping the models to levels/test/map/

try that

or, you're not decrapping them at all, bt its most likely the first thing

Philly · Post by **Philly** » Sat Jan 05, 2008 6:22 am

Ajax17 wrote:while rebuilding it, I don't get a popup asking me to load the offsets

You're not meant to. Read the tutorial again and follow it properly next time. If you can't follow a tutorial, don't bother asking questions.

ajax17 · Post by **ajax17** » Sat Jan 05, 2008 6:27 am

27. When it asks if it should update the starting offset, click YES!

am i supposed to be using this tutorial and just replacing the peli with the scen?

Pepsi · Post by **Pepsi** » Sat Jan 05, 2008 9:22 am

pretty much yes.