Page 1 of 1
WIP, need help!
Posted: Fri Jun 18, 2004 6:59 pm
by Hylian
Im working on a map in Gmax but there are some problems at hand.
1.whenever i try to export the map using chimp,I get an error saying "frame object was not found"
2.when I run sapien, it just freezes
someone please give feedback.
Posted: Fri Jun 18, 2004 7:09 pm
by Burnination
1. make a small box and then name it frame...then link everythink to it...
2. Not sure...usually it takes a couple of minutes to boot up
Posted: Fri Jun 18, 2004 7:23 pm
by Hylian
now it says there is no geometry linked to frame
Posted: Fri Jun 18, 2004 7:25 pm
by gecko753
did u link the object to the frame right?
Posted: Fri Jun 18, 2004 7:30 pm
by Hylian
im not sure.all the geometry is attatched attached to the frame but i still get the popup.
edit:just figured it out
Posted: Fri Jun 18, 2004 7:56 pm
by Burnination
nope, like this....sry bout the map...its not even a map...i just map it so i could show you...
ps....you might need to make it bigger..to read the font
Posted: Fri Jun 18, 2004 8:17 pm
by Hylian
the data is writing right now,i ts taking kinda long
Posted: Sat Jun 19, 2004 9:14 am
by Hylian
Ok, so it finished writing the data,and I fixed the jms file just like it says in the chimp read me, but I cant get it to work in tool.when I open up tool it closes a second later
Posted: Sat Jun 19, 2004 10:06 am
by hydroxic
you have to use a command prompt to open tool, or u could use HEKter, go to nitrous.halocity.org for that...
Posted: Tue Jun 22, 2004 5:57 am
by GHL
OMG STOP!
dont have the frame inside the level geometry!
move it far out quick!
Posted: Wed Jun 23, 2004 3:07 pm
by Hylian
the frame is outside of the map.anyway,I got HEKter running,but its taking long,is it supposed to take long or is something wrong.