Page 1 of 1
Building the Map
Posted: Tue Mar 28, 2006 1:33 pm
by hihi88
ok so I just finally got done exporting my map into a .jms, after that i went into the commapnd prompt and typed in tool structure levels\splinter splinter and then it said that it was building the 2 kinds of geometry and then it said all the stuff like the file names. soo after it was over it said like ERROR edge #54 is open (red) and alot of those came up sooo what should i do to fix it...?
Posted: Tue Mar 28, 2006 1:44 pm
by Classic
Import the yourmapname.wrl with chimp find the open edge and close it off.
Posted: Wed Mar 29, 2006 3:58 am
by hihi88
where is the edges button?
Posted: Wed Mar 29, 2006 6:44 pm
by Classic
hihi88 wrote:where is the edges button?
Did I say anything about clicking an edge button? But any way I'm refering you to this pic again.
Click import Wrl and then get your Wrl from the Halo CE folder. Go to select by name I think thats hot key is s. Select the chimp errors. See where the white lines are and find the gap out of that area hope that helps. I woln't be on anymore today.
Posted: Wed Mar 29, 2006 6:53 pm
by hihi88
wow shouldnt it close off the edges 4 u when u make a shape?
Posted: Wed Mar 29, 2006 7:08 pm
by nsilva
hihi88 wrote:wow shouldnt it close off the edges 4 u when u make a shape?
You edited the shape and you opened it. Your fault.
Posted: Wed Mar 29, 2006 7:23 pm
by hihi88
this world is just too complicated..
Posted: Thu Mar 30, 2006 11:32 am
by Classic
hihi88 wrote:this world is just too complicated..
Wow just stick it out and it'll become simpiler as you become wiser.