Page 1 of 1
AR-19A1 Rifle
Posted: Fri Jun 24, 2005 9:43 pm
by rossmum
This is a made up weapon for my Insurgency mod for CoD. Took all of about 2 or 3 hours to do; around 1700 polies.
I might add to it later.
Comments?
Posted: Fri Jun 24, 2005 9:47 pm
by Burnination
pretty good...wireframe mb?...cause 1700 is alot for that...
Posted: Fri Jun 24, 2005 10:29 pm
by rossmum
Yeah, the light kinda hides the details... wireframe on the way though.
Ok done. Here:
It's so high because I thought that I had low enough poly to just go for a full donut on the barrel. Most of them went into the barrel.
Posted: Fri Jun 24, 2005 11:26 pm
by vaticinator
suggestion, dont wate poly inside the gun on stuff you dont see ever and have the barrel as a solid, like a cylinder or something, bcos when you come to texturing it can look exactly the same.
Posted: Fri Jun 24, 2005 11:27 pm
by GunxSlayer
awsome dude
Posted: Fri Jun 24, 2005 11:42 pm
by rossmum
vaticinator wrote:suggestion, dont wate poly inside the gun on stuff you dont see ever and have the barrel as a solid, like a cylinder or something, bcos when you come to texturing it can look exactly the same.
Yeah, but I'm too lazy to optimise it at the moment. I'll delete those bits later when I need to. Also I made the whole barrel a donut because it was so low poly I could afford to do it.