Page 1 of 1
Applying UVW maps
Posted: Tue Jul 27, 2004 5:22 pm
by gamble
This question is about the Normals Align button. I saw the scenery tutorial by mattp001 and he used this to perfectly align the angle of the bitmap with the surface. When I push the button, it stays down a little then pops back up. The orange square stays the same as it was and is not aligned. Can someone help me out? BTW im running max 6
Posted: Wed Jul 28, 2004 5:16 am
by gamble
bump
Posted: Wed Jul 28, 2004 8:09 am
by gamble
also i saved the uvw map under the UVW editor so i could use the same pattern again later, but when i loaded it, it came up different.
yeah
Posted: Wed Jul 28, 2004 5:44 pm
by Judge_Bond
cant u stick the image to a face.....im not sure waht ur talking about
Posted: Wed Jul 28, 2004 5:45 pm
by Specter
after you press normal align, did you press Fit? if not, go do that