when I import my models,

HaloJunkEE · Post by **HaloJunkEE** » Thu Apr 01, 2004 7:39 am

Nothing happens....they just stay the same....I did some minor changes to the AR....but when I export from milkshape, and import in HMT the FP model it doesn't do anything just stays the same....

New Age · Post by **New Age** » Thu Apr 01, 2004 7:53 am

finally a question i know how to answer.

Firts what model of the AR did you export and import? Make sure you did the one with the most verticies. What model did you teak? the FP or the 3rd person? i know you said you did the FP but did you put it back over the FP?

DId you properly import it back into halo via HMT 3? to do that click on the model you tweaked and click Import model. Then import the new model.

when your modeling something you cannot add or delete any vertecies. All you can do is move them.

HaloJunkEE · Post by **HaloJunkEE** » Thu Apr 01, 2004 8:05 am

I've done everything you said....Importing and exporting is pretty self explanitory

"IR NOT A NOBO YOU NO!"<--lol...had to put the random n00b slam in there for good measure.....

but yeah...I was modeling th FP(3113 or some amount of vertices) but when I import it.....nothing changes...it just stays the same....

New Age · Post by **New Age** » Thu Apr 01, 2004 8:07 am

When your moving the verticies you should make sure you move the ones on the outside... because if you move the ones on the inside the wont move.

HaloJunkEE · Post by **HaloJunkEE** » Thu Apr 01, 2004 8:21 am

Yeah..I was moving the outside ones...hmmm......dunno

New Age · Post by **New Age** » Thu Apr 01, 2004 8:35 am

try it again... it should work, but.

when your done tweaking the model in Milkshape do you go to file exort?

HaloJunkEE · Post by **HaloJunkEE** » Thu Apr 01, 2004 8:44 am

Yup...I'm pretty sure I did everything right...I know my way around milkshape....

thanks anyways New Age

New Age · Post by **New Age** » Thu Apr 01, 2004 8:45 am

no problem... thats why im here.