Page 1 of 1

Weapon not appearing after being placed in BSP

Posted: Sun Oct 08, 2006 8:23 am
by XXXTestamentXXX
I placed a Carbine in the BSP and saved changes, but when I go to play the map, the carbine doesn't appear?

Posted: Sun Oct 08, 2006 8:42 am
by StalkingGrunt911
Are you spawning high enough above the place you want it at. Maybe it fell through the level. :?

Posted: Sun Oct 08, 2006 8:48 am
by XXXTestamentXXX
How high do you have to spawn them? I spawned the Carbine a few inches off the ground. Ill make it higher, and try that

Posted: Sun Oct 08, 2006 8:56 am
by XXXTestamentXXX
Nope, spawning higher did not work. Perhaps I have too many spawns on the map, because I noticed that one of the three phantoms I have does not spawn, either, but the other two and the pelican spawn fine.

Posted: Sun Oct 08, 2006 9:04 am
by StalkingGrunt911
Well first of all use the edit button so you don't double post.
Ok then that could be the problem or maybe you accidently switched it to make it spawn in a certain gametype. Just go to the [sncr] tag go to the chunk that has the information about the spawning etc. Then see if it is set to a certain gametype. If it set to something else just set it to All. If that works then do the same for your phantom. :wink:

Posted: Sun Oct 08, 2006 11:19 am
by XXXTestamentXXX
Where does it show you what gametype it spawns on? Im in the idents, but I don't see gametype...

Posted: Sun Oct 08, 2006 11:49 am
by StalkingGrunt911
XXXTestamentXXX wrote:Where does it show you what gametype it spawns on? Im in the idents, but I don't see gametype...
It would show it in the Meta Editor. Just scroll down until you find Netgame Equipment.