HaloMods "Classic" Read-only Archive

I changed the water level of headlong to 10 not hex editing and everytime I go in the game and see the water its raised up in the air but its not all over the map just where it usually spawns at could someone tell me how to fix this

StalkingGrunt911 wrote:I changed the water level of headlong to 10 not hex editing and everytime I go in the game and see the water its raised up in the air but its not all over the map just where it usually spawns at could someone tell me how to fix this

Hmm, thats odd, as if you look under the BSP the water surrounds the enitre map. What did you use to change hte water level?

the water is around the entire map... that's impossible to raise one section.. X_x; how the hell did you do that?

i thought the water was only were you can see it.... cuz in that little dip/dugout place under the cranes that is lower then the water level...
don't u need to put the spread up?

Well once again the plugin rarely every worked properly... Try hex editing... Or do you want me to upload a patch for you?

maybe im the only one who noticed but entity can change water level now

yeah i made a tutorial on how to use the plugin with entity and it works everytime look in my sig

you dont have a sig...... and all you do is change a value

LuxuriousMeat wrote:you dont have a sig...... and all you do is change a value

Yea I took it out because MT told me that it wasn't the plugin that was doing it it was the .ent plugin that was already there

Umm, in Headlong, i was told you need to apply Greennc's skin to the water and it can change the water level, then you just hex edit.

-DeToX- wrote:Umm, in Headlong, i was told you need to apply Greennc's skin to the water and it can change the water level, then you just hex edit.

no thats just to skin it but all you got to do is open up a map with water in entity then go to the sbsp tag and scroll down to the very bottom and change the water level

he's right, you need to inject the bitm that greennc used to get the water to cover the entire map. The location that the water covers is determined by the bitmap, and on most maps such as zanzibar, water just covers the whole map because the point where the water lies is the lowest point in the map. However in headlong, if water covered the whole map, then most of the map would be underwater, so they had to limit the area it covers by altering that bitmap, but if you inject the bitm that greennc used it removes the limitations and makes the water cover the whole map.