HaloMods "Classic" Read-only Archive

I was using HHT and i loaded Pillar of Autumn for halo pc and then it said an error occured so i exited out and then when i went to start it back up this came up


I dont know why the pic is so small....and please ignore the crazy lady screaming at me on messenger. but it says Application has generated an exception that could not be handled.

Process id=0xd78 (3448), Thread id=0xd7c (3452)

Click OK to terminate the application.
Click CANCEL to debug the application.

then when i click to debug it says this

Registered JIT debugger is not available. An attempt to launch a JIT debugger with the following command resulted in an error cod of 0x2 (2). Please check computer settings.

cordbg.exe !a0xd78

click on retry to have the porcess wait while attaching a debugger manually.
Click on cancel to abort the JIT debug request

Where did you load the Map from? Did you put all the Maps in a Folder in your Documents and load the Map from there?

I loaded it from my MAPS folder...so yes

Is it the Maps folder you made yourself?