Pelican problem

bloodalcohol · Post by **bloodalcohol** » Thu May 05, 2005 6:37 pm

i pmied it all good , i switch the gun turret in deathilsland with the peli, and the p-driver, to w-driver , and i can fly it , but in the passegers section, behind, i cant get IN the pelican like , i can in enter only the passagers close to the outside, but i cant get IN the passagers , like theres an invisible wall or something , HELP!

Spanky_R · Post by **Spanky_R** » Fri May 06, 2005 6:49 am

It has to do with the passenger seat names like P-riderLF etc. They cause a invisible wall in the back. The only thing you can do is make the seats w-passanger. But then you look SOOO stupid riding in it.

bloodalcohol · Post by **bloodalcohol** » Fri May 06, 2005 8:37 am

i dont get it , i did that , and the seat 1 is drive, but oh well : (

Spanky_R · Post by **Spanky_R** » Mon May 09, 2005 6:43 am

Well I did it and I can get in the back... Try and remove the wall in Milkshape. i can't give you any help there modelling isn't my thing...

bloodalcohol · Post by **bloodalcohol** » Mon May 09, 2005 11:34 pm

but u extracted the peli from which map?????

( Just anser the question , but just to make sure heres wat i did >>>>
extracted DI , bsps , open b40, extracted peli, offsets, then loaded it and extracted the peli into vehicles>pelican( of the new folder called peli, not the actuall DI batch extract folder,, decrapped it mod2, then copied the files into the DI folder, overwrting the folder thingy, then copoed the new sbsp into levels test DI , rebuid ,added peli mod2 and peli vehi, new vertices and indicies from the bsp folder , and then , on hmt copied the meta peli and replaced the tank with it , and then switch the p-driver with W-drive , and the rest wast w-passenger until seat 6, at seven i left it cargo, and the rest havent touch it, in game it works, i can fly it 100%, but i cant get in the backside, its like in singleplayer campaign, where i cant get in ,)

thats how , anywyas, just anser the map questioN!