Page 1 of 1
How do i make a hole in a base's wall?
Posted: Tue Oct 30, 2007 3:07 pm
by Kael-Thas
I just want to know how to make a hole in a bases wall. I know it has somthing to do with vertices but i don't know how. If you know how to then could you please tell me? Thanks.
Posted: Tue Oct 30, 2007 4:37 pm
by hell_knight
delete the faces and make new ones
Posted: Tue Oct 30, 2007 7:48 pm
by xxQTip05xx
use the extrude tool in max.
Posted: Tue Oct 30, 2007 8:43 pm
by johnnyblaz20
To make a hole in a wall there are many options. You can use cut to make more edges on both sides. Use the X Y Z to make the edges the same height. And like hell_knight said. delete faces and then maybe bridge the edges. or create new faces using create.
Or totally delete the wall. make a smaller box or cylinder. place it where you want your hole. delete the sides connecting the outside to the inside. and re-create your wall around it using the create tool.
And those are probably the most noobish techniques.